So, here’s my instructions for a Knitted Cloak!

Image and video hosting by TinyPic

I used a size 10 USA needle. I will insist you find out the X measurement, and that is the length from the bottom of your elbow (bent and hanging straight down from your shoulder) to the ankle. This is the only variable for my pattern. It is where the opening for your arms will be and where the top, fitted part of the pattern begins. This pattern is not for beginners. There is a lot of seams to sew and some skill with sewing flat seams is a benefit.

Yarn: 11 balls of Loops and Threads Country Loom 104 yds/95 m apx (I used the color Weathered Rock).
Needles: 7 mm (US 10)
Gauge: 12 sts = 4 inches on 7.0 mm needles over stocking stitch
X – measurement: 38 inches from elbow to ankle.
Stocking stitch: Knit right side row, purl wrong side row.
Seed Stitch: Row 1: Knit one, purl one, repeat. Row 2: Purl the knits and knit the purls. Repeat row two for seed stitch.

Back: Cast on 90 stitches. Work in seed stitch for 2 inches. Then change to stocking stitch and work the back, decreasing one stitch each side every 6 inches until 80 stitches. Work even until back measures X. (place contrast yarn to mark this row)
Continue in stocking stitch, decreasing one stitch each side every 6 rows, until 70 stitches.
Then decrease one stitch each side every 4 rows until 68 stitches remain. Decrease one stitch every 2 rows until 56 stitches remain. Work even until you are 16 inches above the X marker.
Cast off for shoulder: cast off 3 stitches at start of next 4 rows, then 4 stitches at start of next 4 rows, then 5 at start of next 2 rows. Cast off remaining 18 stitches.

Front right: Cast on 45 stitches, work seed stitch for 2 inches. Change to stocking stitch and work decreasing at the start of row only every 6 inches until 40 stitches. Work even until you reach the X measurement. (place marker) Work 28 stitches, attach a new ball of yarn and cast off 2 stitches, work last 10 stitches. Continue in stocking stitch working both sides of the armhole with different yarn balls*** at the same time*** start decreasing one stitch at start of every fourth row. Work opening for 8 inches, then cast on two stitches over the opening and use one ball again to close the hole. When 28 stitches are reached, work even until you are 16 inches above the X marker. On shoulder side: cast off 3, 3, 4, 4, 5 … AND on the neck side cast off 6, then 3, then work even until all stitches are cast off.

Left Front: Work the same as right, reversing the directions.

Band: Cast on 30 stitches, work seed stitch for X measurement. (place marker) Decrease one stitch at the start of the row, every 6 rows, until 22 sts remain. Work even until 15 inches above the X marker (slightly less than the front edge, so that the band can be sewn with a slight stretch to support the long yardage). Cast off all stitches. Make another band the same (right and wrong sides look the same)

Hood: Cast on 50 stitches. Work 8 stitches in seed stitch, 34 in stocking stitch, and 8 in seed stitch. Next row, increase 20 stitches across the stocking stitch section only. continue in 8 seed, 54 stocking, 8 seed for 15 inches. Cast off all stitches. Sew top of hood seam.

Sew side seams up to top of shoulder on both sides. Sew bands to front edge stretching slightly to fit evenly and placing the decreased edges against the front edge.
Attach hood to neck opening, leaving about 4 inches of seed band open to overlap with pin or button.

Armholes: use single crochet to stabilize the edge closest to the center front. On the outside edge of armhole, pick up 24 stitches and work 2 inches of seed stitch then cast off. Sew the short edges down.

To make closure, either find a nice clasp, or add on three buttons. On this I also have three buttons on the inside band to keep it from wandering.

Take your time and be patient! Your blanket like cloak will be worth it!

Print Friendly, PDF & Email